Machining

Outstanding service, great outfit run bu awesome folks.

donalds machine took a pump from me to build new bushings for the shaft, the next day i went to pick up the small hydralic pump for a snow plow and payed $300 the shaft was so tight it would not turn. i left it with and they drilled it out too big. i took the pump and tried it and it did not work. i returned the pump and was told the shaft was worn out and that was the problem at no time was i advised that this shaft was worn or the job might not work but that i am out of luck and $300 i doubt that the shaft was worn as these are brass bushings but i am going to take it to a real machine shop (Earnie Armstrong Machine) to see if this is true at any rate if the shaft was worn they should not have proceeded without consulting me. I ordered and recieved a new pump for $260 I had no idea they would charge me that much or screw up the job FOLLOWUP; i took the same pump to armstrong machine where they built the bushing in one piece instead of two i havn't tried it yet but it seems good and it cost $80 i am still out $300 HEED this warning